Table of Contents
Advertisement
Chase Playback
Manual Chase Playback
Auto Chase Playback
Music Chase Playback
Playback Modifications
MIDI Operation
Setting the MIDI Channel
6. Playback
There are three different modes of playback for the chases in the Obey™ 70. Please see the
sections below for detailed instructions on these modes.
You may activate multiple chases in this controller. They will play back in sequential
order.
You may play back the individual scenes within a chase manually. Please see the instructions
below for further explanation.
1.
Enter program mode.
2.
Activate the desired chase.
3.
Press <TAP SYNC/DISPLAY>.
4.
Use <BANK UP/DOWN> to scroll through the scenes within the chase. The current scene
will be shown on the display as [STEP ***].
You may control the playback of the chases in this controller by using the <SPEED> and <FADE
TIME> faders. Please see the instructions below for further explanation.
1.
Activate the desired chase by pressing <CHASE 1~6>.
2.
Press <AUTO/DEL>.
3.
Using the <SPEED> and <FADE TIME> faders, adjust the playback speed and transition
between the individual scenes (steps).
You may synchronize the playback of the chases in this controller to the beat of the music.
Please see the instructions below for further explanation.
1.
Activate the desired chase by pressing <CHASE 1~6>.
2.
Press <MUSIC/BANK COPY>.
The controller will only respond to MIDI commands on the MIDI channel when it is set to full stop.
Perform all MIDI control using Note on commands. All other MIDI instructions are ignored. To
stop a chase, send the blackout on note.
The controller is always in MIDI receive mode. It is not necessary for the display to read
[MIDI] for the controller to respond to MIDI commands.
1.
Press <MIDI/ADD>. The display should read [MIDI] and the current channel assignment.
2.
Using <BANK UP/DOWN>, select the MIDI channel (1~16).
3.
Press <MIDI/ADD> to save the setting.
17
10/28/2010 4:27 PM
Hide quick links:
Advertisement
Table of Contents
