What To Do If - AEG COMPETENCE B5741-4 User Information

What to do if ...

Problem
The oven does not heat up
The oven lighting is not op-
erating
Pyroluxe is not working
("C1" appears in the display)
The oven door is locked
In the clock display you see:
E001
E020 (when operating nor-
mally)
E021
In the clock display you see:
E020 (when pyroluxe is op-
erating)
In the clock display there ap-
pears a fault code that is not
listed above
50
Possible cause
The oven is not switched on
The clock has not been set
The required settings have
not been set
The oven's safety cut-out has
been tripped
The fuse in the house's elec-
trical wiring (fuse box) has
been tripped
The oven bulb is faulty
The oven shelf supports have
not been removed
Appliance is not connected
to the electricity; door lock is
activated
Temperature outside the per-
mitted range
Door is not closed properly
Fault in the electronics
Remedy
Switch the oven on
Set the current time on the
clock
Check the settings
See "Safety cut-out"
Check fuse. If the fuses trip
repeatedly, please call an au-
thorised electrician
Change the oven bulb
Remove oven shelf support
Connect the appliance to the
electrical supply and wait at
least 10 seconds until the red
temperature pilot light goes
out
Please contact your local
Service Force Centre.
Close the door properly and
start the pyroluxe again
If displayed again, please
contact your local Service
Force Centre.
Switch off the appliance via
the house fuse or the safety
switch in the fuse box and
switch it on again.
If displayed again, please
contact your local Service
Force Centre.