Audiovox FRS122-2 Owner's Manual page 11

FRS Operation:
- Press and hold the Power On/Off button for 2 seconds to turn on
power.
- Press the MODE button so the Channel number flashes.
- Select the desired channel with the Up (10) and Down (11) Buttons.
When receiving a call, the
call.
- Press and hold the PTT button (4) to transmit, then speak into the
microphone clearly and slowly. The Transmit icon (
on the display while the button is pressed.
- Release PTT Button (4) to receive.
- Communication can only be accomplished when the channel and
CTCSS tone frequency of at least two parties are the same.
- The CTCSS subcode (01-38) will be displayed on the LCD panel if the
CTCSS tone frequency function is enabled (not oF).
Channel Selection
In order to communicate with other
ting and receiving party must be on the same frequency.
The FRS122-2 has 14
digits on the LCD display panel. Channels 1 through 14 are the shared
FRS channels.
Communication with Audiovox
and compatible units is possible on these
mitting on the selected channel, press the Monitor (M) Button (2) to check
the activity on that channel. If there is activity on the selected channel,
change to another channel that is clear.
icon appears to indicate an incoming
FRS units, both the transmit-
channels (frequencies) indicated by the large
FRS
14 channels. Before trans-
11
) appears
128-6675
11 of 24