Installation - Binatone Speakeasy 6 User Manual

2. Installation

1. Locating the Base unit
The Base unit should be placed on a level surface, in a position where:
the mains adapter plug will reach an easily accessible 230-V AC
switch mains supply socket - never try to lengthen the mains power cable.
the telephone line cable will reach your telephone line socket or
extension socket.
it is not close to a sink, bath or shower, or anywhere else where it
might get wet.
it is not close to other electrical equipment - fridges, washing
machines, microwave ovens, TVs, fluorescent lights, etc.
2. Plug the coiled handset cord into the Handset. Plug the other end into
the jack on the left side of the Base unit.
Note: The base unit does
require a battery.
3. Place the Handset in
the Base unit.
4. Plug the telephone line cord into
the PHONE LINE jack at the back
of the Base unit. Plug the other
end into a modular
wall jack.
Always use the telephone
line cord supplied with your
SpeakEasy 6. Other telephone
line cords may not work.
The SpeakEasy 6 Base unit must be used
only with the supplied mains adapter. Using
any other adapter may damage the unit.
5. Plug the power supply
cord into the POWER
jack at the back of the
Base unit. Plug the other
end to a 230V AC, 50
Hz mains socket, with
the switch on the socket
set to OFF.
6. Switch ON the mains
power at the socket.
7. Lift the Handset and
check for Dial tone in
the earpiece.
4