Main Menu - Actron OBD II AutoScanner CP9135 Instructions Manual

To Erase Codes, press the ERASE
key. This function can also be run by
selecting Erase Codes from the Main
Menu.
Before erasing codes, the AutoScanner will perform the Read Codes
function and display the number of DTCs stored in the vehicle's
computer memory.
!
CAUTION! Avoid Cooling Fan! It May Turn On During Test.
If no DTCs are present, then press
ENTER to return to the Main Menu.
If DTCs are found, the tool will
display the quantity and ask the user
"Erase Codes? (Y/N)." Pressing the
NO key will display the message
"Cancelled, Erase Not Performed."
Press the BACK key to return to the Main Menu.
Pressing the YES key will display a
scrolling message on the bottom
line. Turn key On, engine Off and
then press the ENTER key.
The AutoScanner will perform Read Codes again to check the number
of DTCs erased.
If all DTCs have been erased, a
message "No Codes Remain (Press
ENTER)" will scroll across the
bottom line.
If DTCs still exist, the number will be displayed. The faults must be
repaired to remove these DTCs. Press ENTER to return to the Main
Menu.
"Hard" codes are codes that can be removed only by repairing
!
the faults that they cause; therefore, hard codes will remain in
the computer's memory until the condition is repaired.
3-4

Main Menu

2)Erase Codes
No Codes
Press ENTER To Exit
5 Codes
Erase Codes? (Y/N)
Verify Engine Off, Key
ERASE DONE
No Codes Remain (Pres
Using the Tool