3.1 AutoScanner Connection and Power-Up
Locate the DLC. If not found, refer to
Section 2.3.
The AutoScanner will not harm the
vehicle.
Remove the protective cap and connect
the AutoScanner's 16-pin J1962
connector. The AutoScanner will
immediately power-up.
The AutoScanner displays its name for a brief period and then begins
"Loading Software."
OBD II
Auto Scanner
If the
key is pressed and held while software is loading, the
Software ID will display until the key is released, and then the Main
Menu will display.
Software ID: 392A
When the Main Menu displays, the AutoScanner is ready to use.
Refer to Section 3.6 - Tool Setup/Test and Section 4 -
Troubleshooting if problems occur.
More information about OBD II can be found in Appendix B - OBD II
Background.
Using the Tool
Loading Software.........
Main Menu
1)Read Codes
3-1