Alarm Lock DL2500-SERIES Programming Instructions Manual
Alarm Lock DL2500-SERIES Programming Instructions Manual

Alarm Lock DL2500-SERIES Programming Instructions Manual

Digital locks

Advertisement

PROGRAMMING INSTRUCTIONS
DL2500-SERIES
DIGITAL LOCKS
U L Listed: Electrically-Controlled Single-Point Lock
© Alarm Lock 1992
OI171A 06/93

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DL2500-SERIES and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Alarm Lock DL2500-SERIES

  • Page 1 PROGRAMMING INSTRUCTIONS DL2500-SERIES DIGITAL LOCKS U L Listed: Electrically-Controlled Single-Point Lock © Alarm Lock 1992 OI171A 06/93...
  • Page 2 UNLOCK TIME …………………………………………………………….….. 5 PASSAGE …………………………………………………………….……….. 6 OTHER IMPORTANT INFORMATION ……………………………………………. USE OF MULTIPLE DIGITS ……………………………….……….……….. 6 ANTITAMPER PROTECTION ………………………………………….…..6 BATTERY REPLACEMENT …………………………………………….…..USER CODE RECORD LOG ……………………………………………….……..7 Alarm Lock Systems, Inc. 345 Bayview Avenue Amityville, New York 11701...
  • Page 3 USER’S GUIDE TO DL2500-SERIES CODES & FEATURES CONGRATULATIONS! Your new Alarm Lock Trilogy electronic digital lock is a rugged entry lock of advanced design with several programmable features. Three security levels are provided: Master, Management, and User, the latter comprising 15 User Codes, including a 1—time entry Service Code.
  • Page 4 validated): [5) [4) [3] [2] [1]. Six beeps will sound and lock will relock after about five seconds. 6. Test the new Master Code. Enter: [5] [4) [3] [2) [1]. A beep will sound and the lock will open. Note: If only one code is required, stop here and proceed to PROGRAMMING SPECIAL FEATURES.
  • Page 5 after the six beeps sound (step 3, above) repeat steps 2 and 3 as necessary, then test all codes when done. SERVICE CODE. The Service Code is a one—time User Code for cleaning crews, babysitters, etc., which erases itself immediately after use. It is programmed as any User Code, with the Program Code AL-3-AL.
  • Page 6 Entry Time 5 sec. 10 sec. 15 sec. 20 sec. Table 3. Unlock Times (times approximate). Note: To conserve battery power, keep unlock time as short as possible. PASSAGE. Programming the Passage Function will maintain the DL2500 unlocked until reprogrammed. To set the Passage Function, enter the Master Code, then press [AL) [4] [AL].
  • Page 7 USER CODE RECORD LOG User No. Description User’s Name Code ______________Master_______________________________________ ______________Management___________________________________ ______________Service______________________________________ User 1________Bank 1, User 1_______________________________ User 2________Bank 1, User 2_______________________________ User 3________Bank 1, User 3_______________________________ User 4________Bank 1, User 4_______________________________ User 5________Bank 1, User 5_______________________________ User 6________Bank 2, User 1_______________________________ User 7________Bank 2, User 2_______________________________ User 8________Bank 2, User 3_______________________________ User 9________Bank 2, User 4_______________________________...
  • Page 8 In no event shall ALARM LOCK be liable for an months following the date of manufacture. ALARM amount in excess of ALARM LOCK's original selling...

Table of Contents