Xerox 6200DX - Phaser Color Laser Printer Troubleshooting Manual page 11

Problem
Printing Is Too Light or Too Dark
in All Colors
Transparency Print Quality
Possible Print Quality defects occurring on
Transparency media such as:
Light and/or Dark spots
Smeared Toner
Light Bands on print
See www.xerox.com/officeprinting/infoSMART on the world wide web for more on-line support information.
Page 3 of 3
Solution
1. Try a different Color Matching mode. From the printer's front
panel Support Menu
select Print-Quality Tips
Note: The TekColor Correction set to Automatic provides the
best results for most documents.
2. If the print is too light, verify that the printer driver Print
Quality Mode or Front Panel Defaults is not set to Draft
Mode.
3. Adjust the light or darkness levels. From the front panel
Support Menu select
Calibrate Colors Menu, then selet
the procedure for Lighten/Darken Colors.
Use only Phaser 6200 Transparency.
®
Using non-Phaser 6200 Transparencies may cause print-
®
quality problems or damage the printer's Fuser.
Damage caused by using non-supported media will not be
covered under the warranty, service agreement or Total
Satisfaction Guarantee.
For a list of Transparency part numbers, refer to the printer's
Paper Tips Page.
select Improve Print Quality?, then
Page. and press OK.
Improve Print Quality?, then select
Print Tutorial Page. Follow