Table of Contents
Advertisement
14
Water Supply Connection
1
Locate the compression fitting and ferrule packed in the
unit. Slide the compression fitting and ferrule over the
1/4 inch water supply line. Do not use thread sealing
compound or tape. Using two wrenches, tighten the
compression fitting on the supply line (see Figure 8).
2
Carefully bend the water supply line into position and
connect the line to the solenoid valve (see Figure 9).
Avoid kinking the water supply line.
3
For recessed installations, allow extra water supply line
length to provide slack for easy removal from the
recessed area (see Figure 10). This will also safeguard
against kinking the line.
CAUTION
CA
CA
UTION
UTION
UTION
CA
CA
UTION
!
After completing the installation, turn on the water and
recheck water and drain connection for leaks. Apply
additional tightening if needed. Do NOT use thread sealing
com-pound or tape.
4
Plug in the power cord.
5
Gently push the unit into position. If desired the unit may
be recessed into cabinet or wall.
6
Allow at least 1-1/2 inches clearance behind the unit for
electrical, water supply and drain connections.
Advertisement
Table of Contents
