Table of Contents
Advertisement
G Configuring the HTTP port number
G DNS update to DNS 1/2 Server
When you set a domain name (FQDN) for the camera, you can access the camera
with the domain name.
G Framerate Control
By setting framerate appropriate for the environment where the camera is installed
or the purpose, you can control the number of images to be sent from the camera.
(Unit: FPS)
Important
If you do not know the subnet mask, consult the provider or relevant network system
G
administration support center.
You do not need to enter the default gateway if the network camera will not be accessed
G
from another network. If you do need to enter a default gateway, consult your network
system administration support center.
When you try to reconnect to the network camera, be sure to confirm that the entered IP
G
address and HTTP port number are new ones if you changed the IP address and HTTP
port number.
Downloaded from
www.Manualslib.com
1) Enter the HTTP port number in "HTTP Port Number" (default: 80).
• For most applications, select 80 (default: 80).
2) Click the "Change" button.
1) To set a domain name, check "Enable". (Default: Disable)
2) Enter both the host name and domain name.
3) Click the "Set" button.
1) Select the framerate from the pull-down menu. (Default: 30, selectable from 1
to 30)
2) Check "limited to". (Default: unlimited)
* The settings above have an effect on all the communication (bandwidth) of the
camera.
* If the current resolution is VGA, 22 fps is the highest framerate. (As for QVGA
or QQVGA, 30 fps)
The framerate you set may not be obtained depending on the networking
*
conditions.
manuals search engine
67
Advertisement
Table of Contents
