Using The Auto Configuration Function - Yamaha MCX 1000 - MusicCAST - Digital Audio Server Owner's Manual

Connecting to the network

Using the Auto Configuration function

The Auto Configuration function automatically
connects your MusicCAST client to a MusicCAST
server. Before attempting to use the Auto
Configuration function, carry out the following
actions:
• Set the MusicCAST server in Auto Configuration
mode (see the MCX-1000 owner's manual for
details).
• If you wish to connect to a MusicCAST server
over a wireless network, check that the
MusicCAST client is close enough to the server to
receive a wireless network signal (see page 25 for
details).
• Check that the MusicCAST client is connected to
an AC outlet.
Carry out the following procedure to configure the
MusicCAST client.
This explanation uses the controller on the
MusicCAST client.
MENU
u / d
SELECT
1.
Press and hold MENU for two seconds
to return to the Top Menu screen.
MENU
2.
Use the controller on the MusicCAST
client to move the cursor to "Setup",
then press the controller.
The Setup screen appears on the display.
PUSH
SELECT
102_Musiccast_E.p65
PUSH
SELECT
MENU
PLAY
PLAY INFO.
– +
VOL
26
3.
Use the controller on the MusicCAST
client to move the cursor to "Network",
then press the controller.
The Network screen appears on the display.
PUSH
SELECT
4.
Use the controller on the MusicCAST
client to move the cursor to "Auto
Configuration", then press the
controller.
The Auto Configuration prompt appears on the
display.
PUSH
SELECT
5.
Press PLAY.
The Auto Configuration process begins.
If more than one MusicCAST server is in close
proximity AND in Auto Configuration mode,
check the on-screen display of the MusicCAST
server to verify that it is diplaying the client ID of
your MusicCAST client (this may take a few
minutes).
PUSH
SELECT
26
2003.06.04, 16:08