Table of Contents
Advertisement
H
I
ARDWARE
NSTALLATION
2.1
S
U
ETTING
P
1.
Place the case upright on a flat, stable surface with the
rear of the case facing you.
2. Remove the side panels by first removing the
thumbscrews at the rear of the case. Then, grip each
panel at the top and bottom and slide it toward the rear
of the case until it detaches from the chassis.
3.
To remove the front bezel, locate the three plastic tabs
on the left side of the bezel. They fasten the front bezel
to the metal chassis. Release the tabs from the top down
to release the bezel. Swing the bezel open to about 45°
and gently lift the bezel upward, and it will come off
easily. Set the bezel in a safe place.
Note: Do not use your fingernails to pry or lift the panels.
2.2
P
S
I
OWER
UPPLY
NSTALLATION
1.
With the case on its side, align your power supply with
the power supply mounting location near the top panel
of the case.
Note: Power supplies with fans on the bottom of the
power supply will need to be mounted so that the
fan is facing the bottom of the case.
2.
Attach the power supply to the case with the screws
provided.
2.3
C
M
ABLE
ANAGEMENT
There is a cable management compartment behind the 3.5" drive cage.
You can tuck or route excess cables in this compartment.
1.
Open the right side panel as described in section 2.1.
2. Locate the cable management compartment with cable ties
located behind the walls of the 3.5" drive cage.
3.
Tuck or route your excess cables to the compartment. This will
keep the cables from interfering with airflow in your case and help
with cooling.
4. Use the cable ties provided to hold them in place.
G
UIDE
5
Advertisement
Table of Contents
