Hardware Installation Guide; Setting Up - Antec SONATA IV User Manual

Hardware Installation Guide

2.1

Setting Up

1. Place the case upright on a flat, stable
surface.
2. Loosen the thumbscrews from the left side
panel. Remove by swinging panel out.
3. Loosen the thumbscrews from the right side
panel. Remove by swinging panel out.
Note: Do not use your fingernails to pry or lift
the panels.
4. Inside the case you should see a brown box
secured by a single screw. Inside the box
are parts and screws you may need during
installation. These parts and screws are as
follows:
A. Front panel keys (2)
B. 2.5" drive bay thumb screw (4)
C. Motherboard standoff (9; 6 preinstalled)
D. Motherboard / auxiliary screw (15)
E. Optical drive / 5.25"-to-3.5" adapter bracket screw / side filter screw (18)
B
A
4
C D E