Removng/Replacing The Pc Card Module - Acer Extensa 900 Series Maintenance Manual

6.5.14 Removing/Replacing the PC Card Module
To remove and replace the PC Card Module Assembly, use the following procedure:
1. Turn off the computer; disconnect the AC power adapter (if it is attached),
and remove the battery pack and PCMCIA cards as described in Paragraphs
6.5.1 and 6.5.2. Also disconnect the MPB (Paragraph 6.5.3) if attached.
2.
Remove the Keyboard Assembly as described in Paragraph 6.5.5.
3. Remove the Heat Sink Assembly as described in Paragraph 6.5.6.
4. Remove the Display Assembly as described in Paragraph 6.5.7.
5. Remove the four screws that secure the PC Card Module to the Main Board
(refer to Figure 6-19).
6. Replacement is the reverse of Steps 1 through 5.
Main Board
Assembly
Figure 6-19 Removing/Replacing the PC Card Module
6-26 Field Service
PC Module