Installing A Device In The Mass Storage Module - HP Model 748 - VME Workstation Owner's Manual

NOTE:
6-8
Installing and Configuring Mass Storage Devices
Installing Mass Storage Devices

Installing a Device in the Mass Storage Module

1 Remove the new device from its shipping box
2 Ensure that the hardware SCSI bus address selected on the device is not
already used by the system.
3 In the case of a removable media device (flexible disk or DDS tape) note
any special requirements for bezel installation.
Installing a floppy disk drive or a DDS drive requires a large bezel for the
upper right or lower left position.
4 Find the hardware in the installation kit. This includes four screws with
shoulder washers which you should now insert loosely into the appropri-
ate holes in the lower surface of the device.
5 If this is a removable media device, do the following:
a Remove the appropriate fill-in panel from the access side of the Model
748i by removing the attaching screw.
b Pry off the small front bezel in the removable media device
c Snap on the new, larger bezel.
6 Find the location on the mass-storage module where you want to mount
the device.
7 Invert the device and fit the loosely-fitted screw heads into the large end
of the appropriate keyhole slot, at that location (See Figure 2 for typical
locations and Figure 4 for installation.)