HP C7401A - SureStore Ultrium 230 Tape Drive User Manual page 10

operation
data protection
index of topics
contact hp
home page
before you start
operation
the front panel lights
loading & unloading
replacing a
removable drive
cartridge care
cleaning
one-button disaster
recovery
specifications
diagnostics
troubleshooting
FAQs
SCSI configuration
UNIX configuration
ordering supplies
file:///C|/Documents%20and%20Settings/topher.COL-SPRINGS/Desktop/Ultrium/document/ultrium/user/reseller/eng/operate.htm [11/14/2001 8:10:06 AM]
issued october 2000 :
operation
contents of this section
switching on the drive
if you have problems during self
test
resetting the drive
switching on the drive
if you have problems during self test
If the Ready light goes off but the all the other status lights show steady amber at
the end of the self-test, this indicates a fault condition:
If you have just installed the drive, check the installation for loose
connections and repeat the self-test.
Try the troubleshooting procedures
is.
If the fault condition persists, call for
resetting the drive
http://www.hp.com/go/support/tape
related topics
interpreting the front panel lights
cartridges
labeling and write-protecting
loading and unloading
caring for
replacing a removable drive
Internal drives are powered on when
you switch on your computer.
Removable drives are powered on
when you switch on your tape array and
computer.
Switch on external drives using the
power switch on the front panel, and
then switch on the computer.
to determine what the problem
assistance.
There is an Emergency Reset on internal,
external and removable drives. Use this to reset
the drive without powering off the drive and
computer, for example if the drive stops
responding. (Use something thin, like the end of a
paperclip to press the reset.)
hp learning products
may have a later version
© 2000, Hewlett-Packard Company