Dell PowerVault MD1120 Installation Manual page 19

Installing the System in the Rack
CAUTION:
If you are installing more than one system, install the first system
in the lowest available position in the rack.
CAUTION:
Because of the size and weight of the system, never attempt
to install the system in the mounting rails by yourself.
To install the system on the rack, perform the following procedure:
1 From the front of the rack, position the system in front of the mounting
rails you installed in the rack cabinet.
Figure 1-7. Installing the System in the Rack
1
1 mounting rails (2)
2 Slide the system fully into the rack until the system front panel is touching
the vertical rails (see Figure 1-7).
3 Tighten the captive thumbscrews on each side of the system's front panel
(see Figure 1-7).
4 Attach the power cord and cables to the system and then connect
the system to the electrical outlet.
2 thumbscrews (2)
Rack Installation Guide
2
17