Cleaning Procedures - Kodak i1440 User Manual

Cleaning procedures

5-2
Cleaning your scanner and preventative maintenance on a regular
basis is required to ensure the best possible image quality.
Some document types generate more paper dust and debris and may
require more frequent cleaning than recommended.
Before cleaning your scanner or replacing parts, review the following
information:
• Some debris from the rubber tires on the feed and separator modules
is normal. Tire debris does not always mean that the tires are worn or
damaged. After cleaning, inspect the tires for wear and replace the
separator module or feed module if necessary.
• When cleaning rollers/tires, allow the rollers/tires to dry completely
before scanning.
• Use only the recommended cleaning supplies. Using unapproved
cleaning fluids or solvents may damage the rubber tires.
• Do not use cleaners in confined areas, use with adequate ventilation.
• Do not use cleaners on hot surfaces. Allow surfaces to cool to
ambient temperature before use.
• Do not use canned/compressed air.
• In addition to the recommended cleaning supplies, you may use a
vacuum cleaner to remove debris from the scanner.
• Staticide Wipes contain isopropanol which can cause eye irritation
and dry skin. Wash your hands with soap and water after performing
maintenance procedures. Refer to the Material Data Safety Sheet
(MSDS) for more information. The MSDS is available on the Kodak
web site at www.kodak.com/go/MSDS.
• The roller cleaning pad contains sodium lauryl ether sulfate and
sodium silicate which can cause eye irritation. Refer to the MSDS for
more information.
A-61550 February 2010