Installation And Adjustment; Usage Of The Drain Hose - Haier HWM88VA User Manual

Installation and adjustment

Please install and adjust the machine according to the requirement of
the manual. It is very important to your security and correct operating
the machine.
Install the lint filter
After opening the package,please take out the lint
filter from the document bag,install it to the overflow
filter of the wash tub.See to the figure.

Usage of the drain hose

The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be
less than 10cm , or the drainage will
not be smooth enough and cause
incomplete drainage.
2.Do not tramp or press the drain hose.
3.If the drain hose is too long, cut it at mid point.
To make smooth drainage, cut the front end of
the hose slantingly.
4.If extra drain hose is needed , please make
separate purchase. The inner diameter of the
extra hose shall not less than 30mm, and the
length shall not exceed 1.5m.
If the extra hose is too long, cut it either
at point A or B.
4
Overflow filter
Lint filter
<10cm
> 30mm
<1.5m
A B
Midway spinning
1.Put the laundries into the spin tub evenly and smoothly.
2.Spin
(1) Put the gland in properly.
Please put in the gland properly even if the laundries quantity is small.
Push
Gland
Proper The laundries
are slanting
(2) Close the inner and outer cover of the spin tub.
(3) Spin for 1-2 minutes.
3.Run the foam-removing spinning.
1 Set the inlet selector handle on spin side and
fill water for about 1 min.
In case water flows out from wash tub side
due to too much inflow, please turn down
the water tap a bit.
2 Close the spin tub outer cover and spin
for about 1 - 2 min.
Push
Proper
No gland
Outer cover of
the spin tub
Inner cover of
the spin tub
Water inlet
Inlet selector handle
Wash
9
Spin