Lexmark C792 Administrator's Manual page 36

Installing Lexmark Document Distributor
4
Specify a location on a shared cluster disk for the installation, and then click Next.
Note: The installation path cannot contain double‑byte characters.
5
Select the IP address or host name of the logical host of the cluster.
6
If you want to use only IP addresses for a system without reliable DNS, then select IP address only install, and then
click Next.
7
If you are installing a system to recover a backup, then do the following:
a
Select Restore Install (RI).
b
Type the path of the folder containing the .ri file from the backup, or click the folder icon and then locate the .ri
file.
8
Click Finish.
9
Allow the installation to complete, and then click Done.
Installing the load balancer
Do the following on the primary node of the failover cluster that will run the load balancer:
1
If the Lexmark Solutions installation window is not open, then run Setup.exe from the LDD installation package.
2
From the Lexmark Solutions installation window, click Install Enterprise System > Install Load Balancer.
3
Click Agree to accept the license agreement.
4
If necessary, specify a location on a shared cluster disk for the installation, and then click Next.
Note: The installation path cannot contain double‑byte characters.
5
Select the IP address or host name of the logical host of the cluster.
6
If you want to use only IP addresses for a system without reliable DNS, then select IP address only install, and then
click Next.
7
Type the fully qualified domain name or IP address of the logical host where the database is installed.
Notes:
• If you are installing the load balancer on the same computer as the database, then you must still use the
fully qualified domain name or IP address of the logical host on the network. Do not use localhost or the
loopback IP address (127.0.0.1) for the location of the database.
•
For installation on a cluster, the location of the database can be set most conveniently during installation. If
the database is moved, then you must uninstall, and then reinstall the load balancer, or contact Lexmark
Professional Services to assist in modifying your current installation.
8
Select the type of database, and then click Next.
Note: If you are using an Oracle database, then make sure that the database is already installed before
proceeding with the installation.
9
Specify the folder that contains your LDD license files, and then click Next.
Notes:
• If the license files are located on a network share that requires authentication, then you must supply
authentication before specifying the license location. To authenticate with the remote server, click Start >
Run, type the UNC path to the share (for example, \\myserver\myshare\), and then type the user
name and password when prompted.
36