Using The Csalloc Command - Epson ActionNote 866C User Manual

Using the CSALLOC Command

CSALLOC is an MS-DOS program that scans the system each
time you start it for available memory, I/O port, and IRQ
resources. This ensures that Card Soft does not use resources
that other system hardware or software may need to work
properly. CSALLOC maintains the information it collects in a
file called CSALLOC.INI.
You need to run CSALLOC if you want to display the system
resources available to Card Soft or if you've changed port, IRQ,
or memory settings on your system. You should also run
CSALLOC when you install new hardware or software that
requires specific system resources so that Card Soft does not use
the resources instead.
You must run the CSALLOC command from the MS-DOS
command line. Unless you add the directory containing
CardSoft to the path command in your AUTOEXEC.BAT file,
you need to change to your Card Soft directory to run the
CSALLOC command.
Note
Remove any PC cards from the PCMCIA slots before you
run the CSALLOC command.
Using CardSoft
3 - 9