Commands In The Config.sysfile - Epson ActionNote 866C User Manual

Commands in the CONFIG.SYS file
Card Soft may have added some of the following commands to
your CONFIG.SYS file. If you modify this file yourself, make
sure you save it and restart your computer.
CONFIG.SYS commands
Command
devicehigh=c:\cardsoft\<socket
services driver>*
devicehigh=c:\cardsoft\cs.exe
devicehigh=c:\cardsoff\csalloc.exe
c:\cardsoft\csalloc.ini
devicehigh=c:\cardsoft\cardid.exe
devicehigh=c:\cardsoft\atadrv.exe
devicehigh=c:\cardsoft\mtddrv.exe
devicehigh=c:\cardsoft\mtsram.exe
devicehigh=c:\cardsoft\mtddrv.exe
device=c:\dos\emm386.exe
x=d000-dfff
install=c:\cardsoft\cs_apm.exe
* This driver depends on the PCMCIA controller in your system.
Note
PCMCIA software may be installed in C:\CARDWIZ\ or
C:
\CARDSOFT\
Function
Commands necessary for CardSoft
to support fax/modem and
application cards; other types of
cards may require the MTD driver
(see the documentation that
came with your card for
information); contains additional
commands for specific drivers
Provide support for ATA drive cards
and ATA flash cards; install the
atadrv.exe command before the
sramdrv or mtddrv command
Provide support for SRAM cards
Excludes the memory range
D000-DFFF
If your system conserves battery life
using the Advanced Power
Management driver, allows
CardSoft to handle the power
management cycles
Using CardSoft
3-13