Physical Dimensions; Adding Memory; Optional Equipment - Epson ActionNote 700 Installation Instructions Manual

Physical Dimensions

LEDs
Power-Green = power is on;
Yellow = battery is low;
Red = battery is very low, save data;
Red blinking = system is in Suspend mode
drive
Num Lock-Num Lock is on, which activates the
embedded numeric keypad
Scroll Lock-Scroll Lock is on
DC-IN-Yellow = power is supplied by the adapter
and the battery is charging;
Green = battery is fully charged;
Red = battery is too hot or too cold;
Blinking red = battery is installed incorrectly
or is damaged.
Accessories

Optional Equipment

Cl External numeric keypad
RAM, fax/modems, LAN cards, etc.
When traveling by airplane, take the computer into the
EPSON ActionNote 700 Series

Adding Memory

The ActionNote 700 Series comes with 4MB of memory on
the system board. You can increase the memory to 8MB by
installing a 4MB memory module, or to 20MB by installing a
memory module.
16MB
To install the memory module, press the keyboard forward
and lift the front of the keyboard until it tilts back to rest
against the LCD screen.
Locate the three sockets near the center front of the board.
Align the three connectors on the memory module with the
three sockets on the system board; then press it firmly into
place.
Replace the keyboard; then run Setup to make sure the
computer recognizes the new amount of memory.
System Board Major Components
The following table lists the major components on the system
board.
System board major components
4/94 EPSON ActionNote 700 Series-3
sockets