Advertisement
Programming Steps for Quik-Code Wireless Keyless Entry
Step 1: The red
on, wait until it turns off (approximately 20 seconds).
Step 2: Using the end of a paper clip, put the receiver of
the
MVP Into Learn Mode
releasing the recessed learn button located on the super
deluxe wall station. The work-lamp on the MVP will
turn on (or blink off then on) to indicate the receiver is
ready to learn a code. You have approximately 30
seconds to enter the keypad PIN and door code.
Step 3:
Press ON/RESET
red lighting on the keypad will turn on.
Step 4: Enter your
press a key the keypad lighting system will blink off and
on to verify a key has been pressed.
Step 5: The work-lamp on the MVP will turn off when a valid PIN has been learned.
Using the Quik-Code Wireless Keyless Entry
To operate the keypad press the
mistake while entering your PIN press the RESET/ON and wait about 2 seconds
and enter the correct PIN. The numbered keys will remain active for
approximately 20 seconds after the door starts to move. Pressing any one of the
numbered keys during this time will allow you to stop and restart the door's
movement.
For example, press the following keys:
Changing the Quik-Code Wireless Keyless Entry PIN
To change the PIN, follow the programming steps listed above. This will overwrite
the old PIN and replace it with the new PIN.
If the MVP receiver has already learned 8 different transmitter codes and a PIN
from two different keypads, when you press and release the learn button on the
super deluxe wall station the work-lamp on the MVP will start to blink. The MVP
receiver memory must be erased before a new PIN can be learned. Once the
memory is erased a new PIN can be learned. However, erasing the memory also
erases the all of the learned MVP transmitter codes. Once erased, all the
transmitters must be re-learned before they will operate the door. To erase the
transmitter codes and WKE PINs, while the work-lamp is blinking, press and hold
the learn button until the work-lamp turns off (approximately 5 seconds). When
the work-lamp turns off, immediately release the program button. If you do not
want to continue with the erase function, quickly press and release the learn button.
To re-learn the transmitter codes, press and quickly release the learn button on the
super deluxe wall station. The work-lamp on the MVP will turn on (or blink off
then on) to indicate the receiver is ready to learn the transmitter code. Press the
button you want the receiver to learn. The work-lamp will turn off when a valid
transmitter code has been learned. To learn a new PIN, follow the directions above.
lighting should be
Keypad
by pressing and quickly
to turn on the keypad. The
Four Digit PIN
For example, once the MVP is in learn mode you
press the following keys:
RESET/ON
. If it is
Off
. Every time you
ON/RESET 6 9 7 3
, enter your
ON/RESET 6 9 7 3
Learn
Button
Super Deluxe
Wall Station
.
If you make a
PIN.
.
Advertisement
