Advertisement
Quick Links
Wireless Keyless Entry
Proper installation of your radio controls will assure years of
READ THE FOLLOWING INSTRUCTIONS THOROUGHLY
BEFORE STARTING INSTALLATION
Your MVP Quik-Code Wireless Keyless Entry is designed to remotely operate
MVP garage door openers. The system permits the user to select one of 10,000
personal identification numbers (PIN's) and operate multiple doors by using
different PIN's. The radio frequency of the remote controls is fixed and tuned at
the factory; adjustments are not required and should not be attempted by the end
user.
Keep transmitters and remote controls out of the reach of children.
Do not let children play with or use the transmitter or remote controls.
Unexpected door operations can cause personal injury or property damage.
Do not place transmitter where the buttons can be accidentally or
Features of the Quik-Code Wireless Keyless Entry
On/Reset Key: This key turns on the keypad and light system allowing you to
operated the system as well as to see the keys in the dark. The keypad will
remain lit for 20 seconds after the last key is pressed.
Single Button Mode: Once you have entered a valid PIN and your door
operator begins to function, the number keys remain active for 20 seconds.
Pressing any one of these keys sends another signal to the operator and allows
you to stop and start the door operator.
Low Battery Indicator: The lighting for your keypad also serves as a low
battery indicator. When the keypad lights flash on and off the battery should be
replaced with a standard 9 volt battery.
Non-Volatile Memory: It is not necessary to reprogram the keypad after you
replace your battery.
Allstar MVP Quik-CodeTransmitters and Receivers are
compatible with HomeLink®.
HomeLink® is a registered trade mark of Johnson Controls.
by
MVP Quik-Code
Installation Instructions
Model 110927
trouble-free operation
WARNING
unintentionally activated.
ABC
DEF
1
2
3
GHI
JKL
MNO
4
5
6
PRS
TUV
WXY
9
7
8
*
0
#
ON
RESET
Advertisement
Related Manuals for Allstar 110927
Summary of Contents for Allstar 110927
- Page 1 MVP Quik-Code Wireless Keyless Entry RESET Installation Instructions Model 110927 Proper installation of your radio controls will assure years of trouble-free operation READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION Your MVP Quik-Code Wireless Keyless Entry is designed to remotely operate MVP garage door openers.
- Page 2 Mounting the Quik-Code Wireless Keyless Entry Step 1: Choose a convenient location that does not interfere with the normal opening and closing of the door. Keep in mind that some doors swing outward and will damage an improperly located keypad. MOUNT THE KEYPAD A MINIMUM OF 5 FEET ABOVE THE GROUND TO KEEP IT OUT OF REACH OF CHILDREN.
- Page 3 Programming Steps for Quik-Code Wireless Keyless Entry Step 1: The red lighting should be . If it is Keypad on, wait until it turns off (approximately 20 seconds). Step 2: Using the end of a paper clip, put the receiver of by pressing and quickly MVP Into Learn Mode releasing the recessed learn button located on the super...
- Page 4 Operational Check After installing your keypad, check the operation by entering your PIN and door number. Operation should be reliable. However, environmental conditions and the location of the keypad will affect distance. • If the keypad doesn’t activate the operator check the PIN number. The PIN number entered must exactly match the learned PIN number.