Section C: Installing The Operator; Identify Your Door Type - Allstar 6000 Installation And Owner's Manual

IDENTIFY YOUR DOOR TYPE FROM THOSE ILLUSTRATED BELOW AND FOLLOW
104367
SECTIONAL DOOR
CURVED TRACK
HIGH ARC OF
DOOR TRAVEL
TRACK
DOOR
FOR THESE TYPES OF DOORS USE 1/3 HP
MODEL 6000 OR 1/2 HP MODEL 6500 OR 6500-P.
USE 7 FT, 8 FT OR 10 FT RAIL
(MATCH DOOR HEIGHT)
BALANCE YOUR GARAGE DOOR ARE UNDER EXTREME TENSION AT ALL
WARNING
HORIZONTAL
CENTERLINE
LINE
104369
FRONT MOUNTING BRACKET MUST BE INSTALLED TO A STRUCTURAL SUPPORT
(STUD) ON THE HEADER WALL. FAILURE TO DO SO COULD CAUSE SENSING
SYSTEM TO MALFUNCTION, RESULTING IN ENTRAPMENT, INJURY OR DEATH.
WARNING
INSTRUCTIONS FOR THAT TYPE OF DOOR
ONE PIECE DOOR
HORIZONTAL TRACK
JAMB HARDWARE
HIGH ARC OF
DOOR TRAVEL
TRACK
DOOR
SPRINGS, PULLEYS, CABLES AND MOUNTING HARDWARE USED TO
TIMES AND CAN CAUSE SEVERE INJURY OR DEATH IF DISTURBED.
DO NOT ATTEMPT ADJUSTMENT.
VERTICAL
REINFORCE HEADER IF NECESSARY USING A 2 x 6 AND LAG SCREWS
C:
INSTALLING THE OPERATOR
IMPORTANT!
ONE PIECE DOOR
NO TRACK
JAMB HARDWARE
DOOR
JAMB
HARD-
WARE
FOR THESE TYPES OF DOORS USE
STEP 1:
Mounting the Front Bracket — Sectional Doors and One-
Piece Doors with Track (For One-Piece Doors without track see Step 1A,
next): Mark a vertical centerline on the header above the door.
manually raising the door, determine the high arc of the door's travel (see
illustration, above left) and using a level, transfer this measurement to the
header (see illustration at left).
previously drawn centerline, at this point.
Bracket securely wit lag screws as shown on the following page.
necessary, reinforce the header with steel angle iron or wood to ensure a
secure mount.
(NOT PROVIDED).
7
ONE PIECE DOOR
NO TRACK
PIVOT HARDWARE
HIGH ARC OF
HIGH ARC OF
DOOR TRAVEL
DOOR TRAVEL
DOOR
1/2 HP MODEL J6500.
USE 7J RAIL
(FOR DOOR HEIGHT UP TO 8 FT)
Draw a horizontal line, crossing the
Install the Front Mounting
104368
PIVOT
By
If