Installation Of Radio Controls - Allstar 6000 Installation And Owner's Manual

Residential vehicular garage door operator 6000 series

Hide thumbs

Table Of Contents

Table of Contents

D: AUXILIARY EQUIPMENT

A. Attach the"U" brackets to the "L" brackets with a 1/4-20 carriage

bolt, washer and hex nut (provided). Insert the bolt from the

inside of the "U" bracket and hand tighten only at this time.

B. Place the transmitter and receiver units into their respective "U"

brackets. See Illustration, at right.

C. Connect the interconnect wire pair to the garage door opener

terminals marked "4" & "5". Although not required, it is

suggested that the "trace" be connected to Terminal 5. See

Wiring Diagram, Page 21.

STEP 5 :

Final Alignment and Test

A. Reconnect the power to the Garage Door Opener. Keep a

portable transmitter with you to control the garage door opener.

B. Place a solid object one foot in front of the transmitter or receiver. The red LED should go OFF and remain OFF until the

object is removed. NOTE: There may be a slight delay in returning to normal depending upon how long the photosystem

was blocked.

C. Move to the center of the door. Make sure the red LED light is on. Move a solid object slowly through the beam.

The LED should go OFF and then ON. If not, check the wire connections (see Step 3).

D. At this time set or recheck the down limit adjustment and reversing system adjustment of the garage door opener following

the procedure outlined in Steps 1 & 4, Pages 17 & 18. It is VERY IMPORTANT that the door opener's inherent features

operate as intended before completing the photosystem tests.

E. Place an opener insert box or a similar object (at least six inches high) on the floor at the center of the door. Now, attempt to

close the door. The door should NOT close from the portable transmitter, but will close with constant pressure from the

mechanical push button.

F. Remove the obstruction from the photosystem beam's path. Close the door. Toward the bottom of the doors downward

movement, CAREFULLY move a solid object across the path of the beam at the center of the door. The door should

STOP, pause for approximately one second and OPEN. Retest, breaking the beam one foot in front of both the transmitter

and receiver unit while the door is moving downward. The door must STOP and OPEN each time. If not, re-align the

photosystem until proper operation is obtained.

G. Tighten all mounting screws and bolts.