Panasonic Toughbook CF-19KDRAXCM Service Manual page 51

n Line Processing of Antenna Cable of Main Unit
S1:Insulation S2:Bitten S3:Sharp Edge
CAUTION
S4:Part No. Check S5:Other
Cable Process
Step 1
Arrange all the cables (white, black, blue, gray and green)
to the arrow direction.
Pass blue, gray and green Cables through
Step 2
under the FPC of AUDO Board.
Audio PCB Ass'y
Fix the blue and Fix the blue and Fix the blue and
gray cables with gray cables with gray cables with
the Tape. the Tape. the Tape.
Tape
After processing the cables, inserting the FPC
and locking, incline the Audio PCB to the arrow
direction.
Step 9
Connect the blue antenna cable.
Insert into the Clamper.
S2
If poorly fixed, the Cable
catching may occur between
the Board and boss.
Step 10
Screw
Screw
Step 11
Confirm the Cables processed in Step 5 do not
Step 3
exist under the Board, and then fix the Screws.
S2
Screw
Process the ANT
Step 4
Cables.
(white and black)
Insert the FPC. Insert the FPC. Insert the FPC.
Check Locking. Check Locking. Check Locking.
Screw
FPC connection
Screw
Torque of tightening screw :0.2 ± 0.02N·m( 2.0 ± 0.2kgf·cm)
This is because Cable catching may occur
between the Board and boss.
Screw
Screw
Attach the cushion
to the side of rib.
Step 5
Cable(White-L)
Process the additional Cables
(white and black).
*Pass all the Cables through
under the Cushion attached in
Step 3.
Step 13
Step 13
Connect the additional cable (black).
9-28
Process the additional Cables
Step 6
(white and black).
Main Board side
Step 7
Process the additional Cable (gray).
Cushion
Cable
(Black)
Step 8
Connect the gray antenna cable.
Connect the green antenna cable.
Insert it into the boss.
(
Push it downward from
the top of boss.
Cable Holder Cushion
Cable
Cable(Gray-S)
)