Panasonic Toughbook CF-19KDRAXCM Service Manual page 32

2. Disconnect the 4 Cables from 4 Connectors.
3. Remove the 2 Screws <E36-15>.
4. Remove the LCD Back Plate and LCD PCB.
5. Remove the Digitizer.
6. Remove the LCD unit., then remove the LED Plate Holder
and LED module.
9.1.19. Removing WWAN Main Antenna
PCB, LAN-Main BT Antenna PCB,
LAN AUX Antenna PCB and WWAN
AUX Antenna PCB
Pen
WLAN-Main
BT Antenna
PCB
WWAN Main <N1>
Antenna PCB
<N1>
<N1>
1. Remove the 1 Screws <N1>.
2. Remove the WWAN Main Antenna PCB.
3. Remove the 2 Screws <N1>.
4. Remove the WLAN-Main BT Antenna PCB.
5. Remove the 1 Screws <N1>.
6. Remove the WWAN AUX Antenna PCB.
7. Remove the 2 Screws <N1>.
8. Remove the WLAN AUX Antenna PCB.
9. Remove the Pen
10. Remove the two Screws <K10-1-13>.
11. Remove the Pen Holder.
Screws <N1> : DFHE5025XA
Screws <NK10-1-13> : DRHM5025YAT
<K10-1-13>
<K10-1-13>
Pen Holder
WLAN Aux
Antenna PCB
<N1>
<N1>
<N1>
WWAN Aux
Antenna PCB
9.1.20. Removing the Each Cover
DC IN LID Rubber
USB LID Rubber
LAN LID Rubber
Moden/LAN LID Rubber
<N6>
<K12-16>
<K12-16>
<K12-16>
<K12-16>
Battery
LID ASS'Y
HDD LID ASS'Y
Audio
LID Rubber
USB Back
Rubber
RGB
LID Rubber
1. Remove the 14 Screws <N6>.
2. Remove the Modem/LAN LID Rubber, LAN LID Rubber,
USB
LID Rubber, DC IN LID Rubber, Serial LID Rubber, RGB
LID Rubber, Audio LID Rubber and USB Back Rubber.
3. Remove the Rear Cabinet.
(Refer to 7.1.5 Removing the Rear Cabinet)
4. Remove the 6 Screws <K12-16>.
5. Remove the Battery LID ASS'Y, HDD LID Ass'y and
PCMCIA LID Ass'y.
Screws <K12-16> : DRQT26+D3FKL
Screws <N6> : DRHM5025YA
9-9
<N6>
<N6>
<N6>
<N6>
<N6> <N6>
<N6>
<N6>
Serial
LID Rubber
<K12-16>
PCMCIA LID ASS'Y