Panasonic Toughbook CF-19KDRAXCM Service Manual page 37

n Line Processing of Antenna Cable
<Note>
Avoid any stress on the solder.
<Order of fixing screws>
Put the Cable on
each hook.
9.2.4. Setting up the LCD Hinge
1. Wind the Cable coming out of the LCD Unit counterclock-
wise to the LCD Hinge.
2. Set the Lock Plate and the Hinge Top Cover, and rotate
the LCD Hinge to turn the Display Unit to front
3. Put the LCD Cable and the Antenna Cable in the Cable
Holder.
4. Fit another Cable Holder and clamp the Cable Holders in
the LCD Hinge.
5. Fix the LCD Hinge using the 2 Screws <N17> and the 2
Cable Holder Plates.
Screws <N17 > : DXYN3+J8FNL
S2
Detail of "A"
Avoid running
over the rib,
boss and bin to
avoid catching
the Cable when
LCD Rear is set.
A
Wrap around the ANT Cable
and insert between the ribs.
The cushion must come
within ± 2mm from the
center of the rib.
S2
Insert into the Front
rib after wrapping.
Avoid overlapping of the Cable at right and left of the hook as below.
CAUTION
Detail of "B"
Insert into the Front
rib after wrapping.
Insert between
S2
the rib.
Cable Holder
9-14
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
S2
Avoid running
over the rib,
boss and bin to
avoid catching
the Cable when
LCD Rear is set.
B
Put the Cable on
each hook.
Cable
<N17>
Holder
<N17>
Plate
LCD
Hinge
LCD Cable
Holder
Plate Sheet
Cable
Holder
Plate
Cable
Holder
Cable
Holder