Panasonic Toughbook CF-19KDRAXCM Service Manual page 44

n Assembly of the left LED PCB and right LED PCB
LED(L) PCB Ass'y
LED Light Guide Sheet(L)
LED PCB Tape(L)
9.2.9. Setting the Power SW PCB
1. Connect the Cable to the Connector. (CN9)
2. Fix the Power SW PCB using the Screw. <N1>
Screws <N1> : DFHE5025XA
n Assembly of the Power SW PCB
Torque of tightening screw :0.2 0.02N m( 2.0 0.2kgf cm)
(Note) Arrow without specified measurement: 0 ~ 0.5 mm
Power SW PCB 0~1mm
Power Spring Sheet
Spring
Insert into the Knob and
Pin on the Top Case.
Insert the Cushion
between the ribs.
*Avoid coming over.
Screw
Fold the board back and fix with screw.
S1:Insulation S2:Bitten S3:Sharp Edge
CAUTION
S4:Part No. Check S5:Other
LED PCB(L)
Match the edge and attach it.
Avoid running over the LED.
Back side
0 3mm
LED(L) FPC
Match the edge and attach it.
Ensure it does not come over the end
of the Board by 0.5 mm or more.
Avoid coming over it.
Attach 0~1mm
Insert
S2
Avoid catching
the Cable
between the
Board and
boss.
PAD PWB Ass'y
Screw
LED(R) PCB Ass'y
Match the edge and attach it.
LED Light Guide Sheet(R)
Match the edge and attach it.
<N1>
Connector(CN9)
Power SW
PCB
Keep the space of 1 mm between
the Top Case and the rib.
Gasket
Attach to the
indent part of
the USB.
No Screw
Necessary
Screw
Screw
Avoid running over the
Thermal Sheet
rib, Cable and Board
after attaching.
Round to make the brown side
outside and insert the notch.
9-21
LED PCB(R)
LED PWB Tape(R)
Gasket
Process the center
part as illustrated.
Note
Avoid any stress on the
bottom part of the stiffening
Screw
plate during this work.
(If stress is placed, load is
applied on the coating part
and connection failure may
occur.)
Insert the FPC.