Jumper Setting - Acer Aspire XC600 Service Manual

Jumper Setting

This section explains how to set the jumper for correct configuration of the main board.
Jumpers with more than one pin are numbered. When setting a jumper, ensure that the jumper caps are
placed on the correct pins.
The following illustration shows the location of the jumpers.
The following table shows the settings of the Clear CMOS and ME Disable jumper. Place the jumper cap on
pins 1 and 2 to close or short the jumper. Place the jumper cap on pins 2 and 3 to open or clear the jumper.
Jumper
Clear CMOS
ME Disable
Aspire XC600 Service Guide
Type Description
3-pin Clear CMOS
3-pin Disable ME
Setting (default)
1-2: Normal operation (default)
2-3: Clear CMOS data
Before clearing the CMOS, make
sure to turn off the system. See
"Clearing CMOS" section on page 74
for detailed instruction.
1-2: Normal operation (default)
2-3: ME disable
For more information on how to clear
the CMOS datajumper configure the
ME Disable jumper see "Configuring
the ME Firmware" section on page
73.
83