Table of Contents
Advertisement
4.1.3
Post-installation Instructions
Observe the following after installing a system component:
1.
See to it that the components are installed according to the step-by-step instructions in
their respective sections.
2.
Unplug the system unit.
3.
Make sure you have set all the required jumpers. See section 2.3.2 for the correct jumper
settings or refer to the jumper setting label pasted inside the system cover.
Figure 4-1 Jumper Setting Label Location
4.
Replace any expansion boards or peripherals that you removed earlier.
5.
Replace the system cover.
6.
Connect the necessary cables and turn on the system.
Chapter 4 - Installing Optional Components
jumper settings label
4-3
Hide quick links:
Advertisement
Table of Contents
