Konica Minolta bizhub C35 User Manual page 348

Message
[Replenish paper]
[Replenish paper in Tray x
or select other paper tray.]
[Paper Size/Type
Mismatch]
[Load the following paper in
tray x.]
[Paper : xxxxx
[Output Tray Full]
[Output tray full. Remove
paper from the tray.]
[Memory Full]
[Insufficient memory
Cancel the job.]
[Stored Job Error]
[Stored job specification
not correct.]
[Tray x]
[Job Registration Limit
Over]
[Registered jobs reached
limit.]
[Wait for job registration to
complete.]
Status, error and service messages
Cause
There is no paper in
the paper tray
selected for printing.
(when [Auto Tray
Switching] is set to
[OFF])
The type and size of
the paper loaded into
all of the paper trays
are different. (when
[Auto Tray Switching]
xxxxx]
is set to [ON])
The output tray is full
of paper.
The print data sent
from the computer has
caused the memory to
become full.
Tray 3/Tray 4 was
specified for printing a
stored job when Tray
3/Tray 4 is not
installed on the
machine.
When trying to print a
stored job, the
installed memory had
been changed since
the job was stored.
Copy, scan or fax
transmission
operations were
repeated while
printing or
transmissions could
not be performed.
Solution
Load paper into the
specified paper tray.
Load the specified
paper into a paper tray.
Remove the paper from
the output tray.
Cancel the job.
Install Tray 3/Tray 4, or
install the memory that
had been installed
when the job was
stored.
Wait a while. The error
is canceled.
13-43