Load Paper; Connect The Fax Line - Epson WorkForce WF-2530 Start Here

4
Insert the cartridges in the holder for each color, and
press each cartridge down until it clicks.
5
Lower the scanner unit.
6
Press OK to prime the ink delivery system. This takes
about 5 minutes.
Note: The cartridges included with the printer are designed
for printer set up and not for resale. After some ink is used for
priming, the rest is available for printing only in the same printer.
Caution: Don't turn off the printer while it is priming or you'll
waste ink.
Do not press the Wi-Fi Setup button
unless prompted during software installation.
5

Load paper

1
Flip the feeder guard forward.
2
Raise the paper support, pull out the output tray, then
raise the paper stopper.
3
Slide the edge guide to the left.
4
Load paper against the right edge guide and behind the
tab line on the left edge guide, with the printable side
faceup.
Caution: Don't load the paper sideways; always load it short
edge first.
5
Slide the edge guide against the left edge of the paper,
but not too tightly.
6
Flip the feeder guard back.
6

Connect the fax line

To fax, connect the included phone cord to a telephone wall
jack and to the LINE port on the back of your product. To
connect a telephone or answering machine, use the EXT. port
on your product. See the Quick Guide for more details.
Note: If you're connecting to a DSL phone line, you must use a DSL
filter or you won't be able to fax. Contact your DSL provider for the
necessary filter.