[Staple]; Application - Tx Stamp (G3/Ip/I-Fax); Tx Stamp; Stamping Tx Stamp - Konica Minolta bizhub 552 User Manual

5.10 Scan Settings

[Staple]

Select whether to staple the printed sheets.
Item
[Position Setting]

5.10.15 Application - TX Stamp (G3/IP/I-FAX)

TX Stamp

When sending a fax using the ADF, apply this function to stamp the TX Stamp on the scanned originals to
make sure that each page of the original has been scanned. TX Stamp is stamped only on the front-sided
page for double-sided originals.
- When it is stamped, a 3/16 inches (4 mm) diameter pink stamp appears in the location as shown in the
diagram.
- To use TX Stamp, the optional Stamp Unit SP-501 is required.
- The ink used for stamping is consumables. If the ink becomes faint, contact your service representative.
- If mixed originals are loaded, the stamp may not be stamped on the location as shown in the diagram.
- To check that the original has been successfully transmitted, refer to the transmission report or the
transmission result that appears on the setting confirmation screen.
- If the quick memory transmission has been selected, selecting TX Stamp cancels the quick memory
transmission.

Stamping TX Stamp

Select [TX Stamp] in the Application screen.
bizhub 652/552
Description
If you select the type of stapling, you can specify the position.
Front side of original
Original feed
direction
Stamp position
5
5-53