Cancelling The "Delay Start"; End Of Washing Programme; Unloading The Dishwasher - Electrolux ESL 46010 User Manual

electrolux
To cancel a delay start in progress
you have to reset the dishwasher.
Simultaneously press and hold the
two programme buttons positioned
over the word
programme button lights will
illuminate.
Cancelling a delay start involves
also the cancelling of the washing
programme set. In this case you
have to set the washing
programme again.
The dishwasher will automatically
stop and an audible signal informs
you of the end of the washing
programme.
The dishwasher's drying system is
provided with a device that allows air
to circulate inside the dishwasher to
prevent residual steam recondensing
on the dishes as water droplets.
Once the washing programme has
ended
If the On/Off button is pressed or the
door is opened during these 20
minutes, the device will be
automatically cancelled.
Open the dishwasher door.
The indicator light of the
programme just ended will remain
on.
, until all the
1. Switch off the dishwasher by
pressing the On/Off button.
2. Leave the dishwasher door ajar
and wait a few minutes before
removing the dishes; in this way
they will be cooler and the drying
will be improved.
Hot dishes are sensitive to knocks.
The dishes should therefore be
allowed to cool down before
removing from the appliance.
Empty the lower basket first and
then the upper one; this will avoid
water dripping from the upper
basket onto the dishes in the lower
one.
Water may appear on the sides
and the door of the dishwasher as
the stainless steel will eventually
become cooler than the dishes.