How To Set Up A Client-To-Gateway Vpn Configuration - NETGEAR DG834GUv5 Reference Manual

DG834G Reference Manual
• Use the VPN Wizard to configure a VPN tunnel (recommended for most situations):
— See "How to Set Up a Client-to-Gateway VPN Configuration" on page
— See "How to Set Up a Gateway-to-Gateway VPN Configuration" on page
• See "Using Auto Policy to Configure VPN Tunnels" on page 8-36
its VPNC defaults (see
circumstances, but you want to automate the Internet Key Exchange (IKE) setup.
• See "Using Manual Policy to Configure VPN Tunnels" on page 8-48
and its VPNC defaults (see
circumstances and you must specify each phase of the connection. You manually enter all the
authentication and key parameters. You have more control over the process, however the
process is more complex and there are more opportunities for errors or configuration
mismatches between your DG834G and the corresponding VPN endpoint gateway or client
workstation.
Note: NETGEAR publishes additional interoperability scenarios with various
gateway and client software products. Look on the NETGEAR web site at
www.netgear.com

How to Set Up a Client-to-Gateway VPN Configuration

22.23.24.25
DG834G
192.168.3.1
PCs
Figure 8-3
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves the following two steps:
8-6
Table 8-2 on page 8-5) are not appropriate for your special
Table 8-2 on page
for these interoperability scenarios.
VPN Tunnel
v3.0, September 2005
when the VPN Wizard and
8-5) are not appropriate for your special
0.0.0.0
PC
(Running NETGEAR
ProSafe VPN Client)
Virtual Private Networking
8-6.
8-20.
when the VPN Wizard