Viking VMOS201SS Use & Care Manual page 7

See built-in trim kit installation instructions
for proper location when building in
above the specified ovens. Carefully
follow both the oven installation instruc-
tions and built-in trim kit instructions.
The opening in the wall or cabinet must
be within the following dimensions:
A HEIGHT : 16
B WIDTH : 24
C DEPTH : minimum 20"
Outlet should NOT be in the shaded area
as indicated.
1. If the dimension of DEPTH (C) is more than 21", the outlet location may be
any area on the rear wall.
2. The floor of the opening should be
constructed of plywood strong enough
to support the weight of the microwave
oven and floor load (about 100
pounds). The floor should be level for
proper operation of the microwave
oven. Be sure to check the local
building code as it may require that
the opening be enclosed with sides,
ceiling and rear partition. The proper
functioning of the microwave oven
does not require the enclosure.
The built-in trim kit includes all the necessary parts and easy-to-follow instruc-
tions for installation as well as location of the power supply.
The ease of assembly for these kits will allow installation into an existing wall
opening in less than an hour (if power outlet is already properly located).
All it takes are four steps and a Phillips screw driver.
3
/ " - 17"
4
11
3
/ " - 24 / "
8 16
Over Oven Installation
29 / "
7
16
7