Fisher & Paykel DishDrawer DS603 Series User Manual page 33

Problem
Foaming
No detergent
dispensed
Excessive motor
noise
Water leaking
DishDrawer® will
not open
Possible Cause
Incorrect amount of
detergent.
Too much egg in the wash
load.
Rinse agent setting too
high.
Detergent was wet when
loaded.
The filter plate and/or spray
arm is incorrectly placed.
No water in the motor area. This usually occurs on the first use or
Drain hose disconnected
from waste pipe.
Supply inlet hose not
properly connected.
Other leaks.
Childlock function is on or
the Closed Drawer option
is on, or both.
What to do
Refer to the detergent section or
consult the detergent manufacturer's
instructions.
Increase the amount of detergent.
Decrease the rinse agent setting.
Clean the dispenser and ensure the
dispenser is dry when adding detergent.
Refer to the user maintenance section
for details on correct placement.
when the DishDrawer® has not been
used for long periods of time. Run the
DishDrawer® through a wash program.
Reconnect the drain hose to the waste
pipe.
Ensure the inlet hose is connected
securely.
Turn water and power supplies to the
DishDrawer® off. Call your dealer or
Authorized Service Agent.
Turn the Lock function off. Hold down
the / button until the
disappears from the LCD or the light
above the / button disappears
and/or press the
DishDrawer®.
symbol
button to open the
27