Table of Contents
Advertisement
www.packardbell.com
12
Disconnect the touchpad board and touchpad button board cables from
TP335 and FP2 connectors.
13
Carefully pry loose the palm rest from the system and lift the palm rest from
the system.
14
Place the new palm rest assembly on top of the base enclosure and press
it down on all sides until it snaps into place.
15
Reconnect the speaker cable, touchpad board cable, touchpad button board
cable, and DC-in cable to their respective system board connectors.
16
Secure the palm rest assembly with the screws removed in steps
17
Reinstall the LCD panel assembly by following the instructions in
the LCD panel assembly" on page
18
Reinstall the keyboard cover by following the instructions in
keyboard cover"
19
Reinstall the keyboard by following the instructions in
keyboard" on page
20
If you have disconnected any wireless antennas, reconnect them now.
21
Replace the bay cover, then tighten the cover screws.
22
Reinstall the battery.
83.
procedure on
page
79.
77.
7
and 9.
"Replacing
"Replacing the
"Replacing the
89
Advertisement
Table of Contents
