Side-By-Side Models - Whirlpool ECKMF94 - Automatic Ice Maker Installation Manual

Side-by-side models
Refer to the side diagram for the following
steps. You will be working inside the freezer
compartment.
1. Remove the phillips screw from the ice
maker wiring cover and remove the cover.
2. Refer to DETAIL A, and with a pair of pliers,
break away the tabs from the wiring cover
and discard them.
3. Insert the blade of a small screwdriver
under the edge of the round hole plug for
the fill tube, (located at the back of the
freezer liner), and pry it out. You can dis-
card the plug.
Refer to the side diagram for the following
steps. You will be working on the outside at
the rear of the cabinet.
1. In the upper right corner of the cabinet, peel
off the label that is over the fill tube hole.
2. Pull the foam insert out of the fill tube hole
and discard it.
Refer to the side diagram for the following
steps.
1. Locate the fill tube and the round foam
gasket from the ice maker kit (the gasket
may already be installed on the fill tube). If
not already done, slide the gasket over the
end of the fill tube.
2. Insert the fill tube through the hole in the
rear of the refrigerator with the spout facing
down, and secure it with two lh" hex-head
sheet-metal screws.
ln8ert pin
0
Wiring
harness
c)
slot
Phillips
.++ 8crew
Tab
Insert tab
into slot
Break off and discard
Ice maker wiring cover
000
Foam insert
Removing the label and foam plug
spout / I
Foam
gasket
I I
Installing the fill tube/gasket
7