Top/Bottom Freezer Models - Whirlpool ECKMF94 - Automatic Ice Maker Installation Manual

Modular ice maker kit
Table of Contents

Advertisement

Top/bottom
freezer
models
Refer to the side diagram for the following
steps.
1. Remove the phillips screw from the ice
maker wiring cover, unhook the right side
tab from the edge of the back cover, and
remove the wiring cover.
2. Look at the back side of the wiring cover
and note the grooved lines. Use a pair of
pliers and bend the areas inside the
grooved lines back and forth until they
break away from the wiring cover.
Refer to the side diagram for the following
steps.
1. Pull the 4-wire ice maker harness out from
behind the freezer's back cover as far as
possible, and hang it over the edge of the
cutout. Do not remove any other wiring from
the cutout.
2. Slide the flared end of the short aluminum
fill tube extension or the short plastic fill
tube extension over the end of the fill tube
as far as it will go (see DETAIL A).
3. Refer to DETAIL B and install the wiring
cover over the fill tube with the wiring har-
ness through the slot. Hook the tab in the
side of the wiring cover into the slot in the
back cover of the freezer, and secure the
cover with the phillips screw you removed
earlier.
Mounting
hole -
Phillips
screw
Tab
Wiring
Removing the wiring panel
DETAlL A
d
14
extension
ab
Installing the short fill tube extension
and reinstalling
the wiring panel

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eckmf952155462

Table of Contents