Turning
the water
on
NOTE: Be very careful when you tighten the
compression nuts that you do not overtighten
them and destroy the compression sleeving
and the end of the soft copper tubing. If this
happens, you will have to cut off the end of
the tubing, purchase a new compression
sleeve, and start over. Be careful and go
slow!
l.Turn on the water supply and check the
shut-off valve for leakage. If necessary,
refer to the side diagram, and tighten the
compression nut on the shut-off valveh
Ho-p:. V&e oithe connection with a cloth
sma I inc eme ts until the leakaae iust
each time you check for leaks.
2. Check the water valve for any leakage. If
necessary, tighten the compression nut
(see the side diagram)
in small increments
until the leak&g iust stops.
T-handle
/
I
I
Tightening the shutoff
valve connection
Compression
-
nut
Water inlet
-
fitting
Tightening the water valve connection
21