Audio output -
Transmission delay
Power supply
Power consumption
Legal notices
FCC and IC Information:
This device complies with Part 15 of the FCC Rules and RSS-210 of the
IC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
38
High efficiency, class D, speaker level
Support for 4- to 8-ohm speakers
Audio power output: 2 × 42 W (RMS) into 4 ohms
15 - 20 ms
AC 120V~60 Hz (RF-RBKIT)
AC 220-240V~50 Hz (RF-RBKIT-05A)
30 W