Console Interface; Power-On Self Test; Boot Rom Command Mode - Asus GX2024B - GigaX Switch User Manual

Layer 2 managed switch

Table of Contents

GigaX2024B L2 Managed Switch User Manual

Console interface

This chapter describes how to use console interface to conﬁgure the switch. The

switch provides RS232 and USB connectors to connect your PC. Use a terminal

emulator on your PC such as HyperTerminal and command line interpreter to

conﬁgure the switch. You have to set up the terminal emulator with baud rate

9600, 8 bit data, no parity, and 1 stop bit, and no ﬂow control.

Once you enter CLI mode, type "?" will display all available command help

messages. This is very useful when you are not familiar with the CLI commands.

All the CLI commands are case sensitive.

5.1

POST is executing during the system booting time. It tests system memory, LED

and hardware chips on the switchboard. It displays system information as the

result of system test and initialization. You can ignore the information until the

prompt, "ASUS>:" appears.

5.1.1

During the POST process, you can enter a "Boot ROM Command" mode by

pressing <ENTER> key. Enter the "?" key to show the help messages for all

available commands.

Note

Figure 58. CLI interface

Although the commands are helpful in some situation, we

STRONGLY suggest users not to use them if you donʼt know the

command function.

Table of Contents

Gigax2024b