Front Panel Operation - Arcam fmj AVR360 User Manual

front panel
operation
input
These buttons select the source
connected to the corresponding
input (or internal input)
Unused sources can be prevented
from being selected in the setup
menu.
Selects between Stereo and the available
surround modes for the current source.
Selects the information displayed on the
lower left portion of the front panel.
ok
Used to enter selections made in the
Setup menu. Press and hold to reset
video outputs to the lowest resolution
(HDMI: 480p; Component 480i).
36
Multi purpose auxiliary
line level input,
calibration microphone
Menu input and 3.5mm optical
digital (SPDIF) input.
Selects the Setup menus on the
on-screen display (OSD).
direct
Stereo Direct on/off. Provides a direct analogue path from
Mode
the analogue inputs to the left and right front outputs.
Switches off any surround processing modes and shuts
down the DSP circuits for best stereo sound quality.
display
info
This switches the display brightness
between off/dim/bright.
Zone
Selects between Zone 1 and
Zone 2 control.
Mute
Mutes all analogue audio outputs in the
currently selected zone.
aux Phones
This socket accepts headphones
with an impedance rating between
32 and 600 , fitted with a 3.5mm
Ω Ω
stereo jack plug.
e-22
Power / Standby led
This indicates the status of the receiver and is
green when the AVr360 is powered on. red
indicates the AVr360 is in Standby mode.
Volume
Adjusts the analogue output
volume in the selected zone
(line out, speakers and
headphones).
Power
Switches the main power to the
AVr360 on and off.
Once the unit is switched off,
it should be left for at least ten
seconds before switching on
again.
Remote control receiver. This is positioned behind
the display window, above the button on the
MENU
front panel. Ensure the receiver is in a clear line of
sight from the remote control for operation. If this is
not possible, use a separate sensor connected to the
input on the rear panel.
Z1 iR