Safety guidelines 9. Power sources SAFETY INSTRUCTIONS Only connect the appliance to a power supply of the type described in the operating instructions or as marked on the appliance. This product is designed and manufactured to meet strict quality 10. Power-cord protection and safety standards.
Dolby Pro Logic or Dolby Digital system. THREE CHANNEL OPTION Contact your Arcam dealer for more information. ‘Daisy chaining’ – The power amplifier can be connected to further The power amplifier can be upgraded from stereo to three channels power amplifiers to drive more speakers (e.g.
If the as all speakers are switched off. If both are on, and low impedance fault cannot be cleared, unplug your amplifier and contact your Arcam speakers are connected, overloads are more likely.
(High Frequency) and (Low Frequency). Two amplifiers – one of these would be the A32 and the other an Arcam power amplifier (e.g. P35). BI-WIRINGYOUR LOUDSPEAKERS Loudspeaker cables – two pairs of cables per loudspeaker or a suitably terminated cable set (a loom, probably prepared by your dealer and capable of being used for bi-amping in one length).
CR-389 remote control 2 x AAA batteries E&OE CONTINUAL IMPROVEMENT POLICY NOTE: All specification values are typical unless otherwise stated. Arcam has a policy of continual improvement for its products. This means that designs and specifications are subject to change without notice.
This equipment should be packed in the original packing and returned to the dealer from whom it was purchased, or failing this, directly to the Arcam distributor in the country of residence. It should be You can register your Arcam product on line at: sent carriage prepaid by a reputable carrier -–...