BENDIXKing KLN 90B Pilot's Manual page 17

3. Turn on the computer being used for the database
update. Insert Disk 1 into the computer's disk drive.
There can be either 2 or 3 disks used for the update so
be sure the label on the outside of the disk says "Disk 1 of
2" or "Disk 1 of 3". The program on the disk will automati-
cally "boot" (load) and the computer screen will display
"Ready" when the computer is ready to continue with the
database update operation.
4. Turn on the KLN 90B. Press
approve the Self Test and Database pages. Use the left
outer knob to select the Setup (SET) type pages and the
left inner knob to select the SET 0 page (figure 2-2).
5. Press the left C. UPDATE PUBLISHED DB will
now be displayed as in figure 2-3.
6. Press E. The database region and the expiration
date of the database presently loaded in the KLN 90B is
displayed (figure 2-4). If the database is out of date the
word EXPIRES changes to EXPIRED.
7. Press E to acknowledge the information on this
page and to continue the update procedure. The esti-
mated load time in minutes is now displayed (figure 2-5).
NOTE: In steps 5, 6, and 7, repeated presses of @ will
terminate the update process and bring the display back
to the original SET 0 page shown in figure 2-2.
E as required to
2-5
U P D A T E
D A T A B A S E
O N G R O U N D
O N L Y
SET 0
Figure 2-2
U P D A T E
D A T A B A S E
UPDATE PUBLISHED DB
CRSR
Figure 2-3
U P D A T E
N AMERICAN
DATA BASE EXPIRES
17 AUG 94
U P D A T E ?
CRSR
Figure 2-4
U P D A T E
D A T A
E S T .
T I M E :
A P P R O V E ?
CRSR
Figure 2-5
ent
ent
B A S E
L O A D
10 MIN
ent
Rev 1