Removing And Replacing The Real-Time Clock - HP j6700 - Workstation Upgrade Instructions

Unix workstations

Hide thumbs Also See for j6700 - Workstation:

Table of Contents

Component Remove/Replacement

Component Removal and Replacement

Removing and Replacing the Real-Time Clock

To remove the real-time clock, you ﬁrst need to follow the procedure in the section "Front

Bezel and Top Cover" of this chapter. After this procedure has been completed, you can

remove the real-time clock as shown in Figure 2-14. You may need to rock the real-time

clock back and forth to loosen it in its socket.

Figure 2-14. Removing the Real-Time Clock

Locator Dot

Real-time Clock

To replace the real-time clock, reverse the above procedure. Note that you should be

careful to not bend any of the real-time clock's pins, and you must position the locator dot

as shown in Figure 2-14. Once the real-time clock is in place, reverse the procedure in the

section "Front Bezel and Top Cover" to replace the top cover.

Chapter 2

Table of Contents

Visualize j6700